Gasket test rigs
The function of sealed
connections is significantly influenced by the properties of the gasket. These
properties take the form of characteristics which are of central significance
for both the selection of the suitable gasket and the required proof of
tightness and strength. Furthermore, these characteristics are required by the
gasket manufacturer for quality assurance.
Based on these
requirements, we have developed a series of test rigs with which the gasket
properties can be determined – accurately and cost-effectively. The development
of the test rigs incorporated the relevant standards and guidelines, as well as
our many years of experience in metrology.
Standards and guidelines
The most important
inspection standards for gasket technology are DIN 28090 and EN 13555. These define the
characteristics, and also define the test procedures for determining these
characteristics. Furthermore, DIN 28091 describes procedures for
quality assurance in the manufacture of flat gasket materials.
The test procedures
according to DIN 52913 and DIN 3535 are also well
established standards in the market, similar to the American inspection
standards ROTT (Room Temperature Tightness Test) or HOBT (Hot Blow-Out Test).
Successful component inspection according to VDI Guideline 2440 is necessary to prove
the quality of a sealing element to meet TA-Luft (the German Clean Air Act)
requirements.
In use worldwide
Today we are regarded as the leading global supplier of gasket test rigs. Our test rigs can be found on nearly every continent. Our service – which doesn't come to an end once the product has been delivered – ensures satisfied customers everywhere. Simple support queries are just as much a part of our range of services as regular maintenance and recalibration of testing equipment.
Our multifunctional test rig TEMES fl.ai1 enables the inspection of gaskets in
- upsetting testing
- ompressive creep testing
- creep/relaxation testing
- leakage testing
at room temperature or raised temperature as well as under load or internal pressure.
The test rig can be operated both manually and fully automatically – which represents a decisive advantage for long testing periods. more...
We developed the TEMES fl.relax test rig especially for creep/relaxation testing to shorten the time-consuming investigation of various parameters (load, temperature, stiffness) by using several test rigs. more...
The TEMES ta.luft test rig was designed for component testing of real flanged connections to investigate gasket quality in terms of the TA-Luft (the German Clean Air Act). Here the sealing behaviour is determined after a previous exposure to temperature. more...
Klinger test rigs
In 2006, we officially took over the support for Klinger testing presses. We carry out maintenance and repairs and offer upgrading of testing equipment with modern hardware and software. more...
Other test rigs
We have also developed
special solutions when required, e.g. a test rig for high temperature
applications up to 800 °C, or for gaskets with large nominal sizes which
needed to be tested in individual segments.
We have also carried out
modernisations to older test rigs from other manufacturers – this is not
limited to Klinger test rigs.
Your contacts for gasket test rigs:
Manfred Schaaf
Queries
Tel.: +49 7133 - 9502-12
e-Mail: TEMES@amtec.de
Claus Reinges
Maintenance
Tel.: +49 7133 - 9502-17
e-Mail: TEMES@amtec.de
Support
e-Mail: TEMES@amtec.de